Locked in Error 14 trying update

[Kyle.E.Woyote]

Well, figured I'd update from 2.15 to 2.18 and long story short..Failed

I'm now locked in error 14 and unable to use the mfc at all.

On intitail update, I did get an error 6, but now I can't do a thing.

The update was performed via fractal-bot thru the Axe II, with usb to on and sysex to none.


any Ideas, I'm panicking now,haha

 

[Kyle.E.Woyote]

Update: problem not fixed, but reverted via midi-ox back to 2.15 without a hitch.

I will try it again after rehearsal tonight. Hoping it's something simple and idiotic I'm doing, which is likely the case...

 

[JIMMY G]

Just a question, are you using the ethernet cable or the power supply to power the MFC? I had trouble using the ethernet cable as power supply when updating. Make sure your in and out are right.

 

[Kyle.E.Woyote]

No I used power supply, fed through midi cable. I will start from scratch again tomorrow hopefully....thanks though!