Loading a new amp block

ssmorga78

ssmorga78

Experienced
Ok, I'm sure that I have read this somewhere, but I can't seem to find it anywhere. If I have a preset saved as a template to make my life easier creating patches...how do you get the factory settings to load when changing amps? Whenever I try that now, a new amp loads but with the same settings as the previous amp. Now, I know I will tweak the controls to my taste.....but I want to make sure that what is programed in there from FAS loads up to start.
 
I just did some investigation shepo1.....when in Axe Edit if you change the amp all the advanced parameters change to the defaults. Its just the tone section that stays where you have it. You can hit reset in the amp block, but its just going to take everything to noon on the controls.
 
Thanks... I just wanted to make sure i was getting all the advanced stuff reset so i can start from a neutural starting point.. Yeks how tos.. explains it as well.
Thanks guys.
 
You must log in or register to reply here.
Back
Top Bottom