• We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.

Line 6 dt25 amp - reverb enable/disable with midi using FX8

M

MesaFormulaFX8user

New Member
I have a Line 6 DT25 amp, and using with a Fractal FX8 - 4 cable method.

I was interested in being able to use midi on the FX8 to enable/bypass the amp's reverb,
but I am not sure how to set this up?

the DT25 amp midi implementation chart reference table indicates:

reverb; bypass/enable - ch A midi CC: 36, ch B midi CC: 105, midi CC value: 0 - 63 bypassed/64-127 enabled

any information greatly appreciated. thanks
 
Last edited:
OrganicZed

OrganicZed

Power User
Yes. You can do this two ways. 1. Use a MIDI block assigned to a footswitch to send CC values or 1. Use scenes and scene mode on the foot switches to send MIDI CC values upon scene changes.
 
OrganicZed

OrganicZed

Power User
I believe what you've posted is correct. You should have all of the information you need to accomplish what you're trying to do.
 
M

MesaFormulaFX8user

New Member
Ok, that is good news.

I will hook up a midi cable going from 'Midi Out' on the FX8 to 'Midi In' on the DT5,
and experiment with settings.


thanks again for the information!
 
Last edited:
You must log in or register to reply here.
Top Bottom