Hi there,
I own a LFPro and just updated to v2.04. I ran the autoload with my AxeFX and as usual it completed without error. My problem is that when I go to the presets the IAs initial states show the opposite value to that in the AxeFX and you have to press the button twice to have any effect. e.g. Preset 1 in the AxeFX has a chorus1 that is bypassed, when I sync with the LF, preset 1 on the LF shows Chorus1 is there but active (Green LED) however Chorus1 is still bypassed in the AxeFX (which is what I want). I then press S7 which is assigned to Chorus1 and nothing changes in the AxeFX and the LED goes red on the LF. I press S7 again and the LED goes green and the Chrous is on in the AxeFX.
Did I miss something in the FW update?
Cheers
Spence
I own a LFPro and just updated to v2.04. I ran the autoload with my AxeFX and as usual it completed without error. My problem is that when I go to the presets the IAs initial states show the opposite value to that in the AxeFX and you have to press the button twice to have any effect. e.g. Preset 1 in the AxeFX has a chorus1 that is bypassed, when I sync with the LF, preset 1 on the LF shows Chorus1 is there but active (Green LED) however Chorus1 is still bypassed in the AxeFX (which is what I want). I then press S7 which is assigned to Chorus1 and nothing changes in the AxeFX and the LED goes red on the LF. I press S7 again and the LED goes green and the Chrous is on in the AxeFX.
Did I miss something in the FW update?
Cheers
Spence