deathsilver
Inspired
Hi all,
Just wanted to inform you of an issue with Axe-Edit I have not see on this forum.
I am running latest firmware for Axe-FX2 Mark II, with latest drivers and Axe_edit version on iMAC Pro 2018through USB-C.
Issue: was getting a tremendous amount of lag changing presets, accessing block parameters etc from Axe-Edit.
Fix: There's an issue with full screen view in Axe-Edit, it is causing the lag. In normal view everything is fine. The lag seems to increase with screen resolution (e.g. at 3200x1800 its unbearable). So the quick fix is use normal view.
I am not sure what is causing this or iFractal is aware of this issue but I wanted to put it out there just in case it can help a few users on here.
I've see lots of posts about lag in Axe-Edit and I am wondering if this may the the cause of some of those reports.
Cheers.
Just wanted to inform you of an issue with Axe-Edit I have not see on this forum.
I am running latest firmware for Axe-FX2 Mark II, with latest drivers and Axe_edit version on iMAC Pro 2018through USB-C.
Issue: was getting a tremendous amount of lag changing presets, accessing block parameters etc from Axe-Edit.
Fix: There's an issue with full screen view in Axe-Edit, it is causing the lag. In normal view everything is fine. The lag seems to increase with screen resolution (e.g. at 3200x1800 its unbearable). So the quick fix is use normal view.
I am not sure what is causing this or iFractal is aware of this issue but I wanted to put it out there just in case it can help a few users on here.
I've see lots of posts about lag in Axe-Edit and I am wondering if this may the the cause of some of those reports.
Cheers.