• We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.

Killswitch Engage Tone Match!

xfigox

Inspired

Tone Match attempt of KSE's End of Heartache. I double tracked the guitars, but I'm pretty sure the album one is quad tracked.

Guitar used was an Ibanez RG2550z, all stock.

Original was a wave file from:
http://soundcloud.com/gtrtracker/killswitch-the-end-of

Amp is the Recto Orange Vintage into the Ownhammer Recto Cab (no mic), theres a slight bit of room in the cab and a very short room reverb used.

EDIT: Reuploaded the patch, seems like something went wrong when exporting it.
 

Attachments

Last edited:

X14Halo

Inspired
This is amazingly spot on. Is there any way that you could upload a clip of what you tone matched to, and the preset that you started with before tone matching? I'm just curious as to how close the sound was before you tone matched. Did you do it with or without a cab?
 

ALPER CAN

New here
Hi i am kind of new to forum. So I imported this to my axe fx 3 using fractool but there is no sound. I checked the cab, output vol but no luck so far. I dont know what am I missing. Can anyone help?
 

bradlake

Axe-Master
Hi i am kind of new to forum. So I imported this to my axe fx 3 using fractool but there is no sound. I checked the cab, output vol but no luck so far. I dont know what am I missing. Can anyone help?
hey alper, several things. when I imported this with fractool, the out 1and In 1 block was zeroed out on volume and panned far left, but when corrected , still no output.
this preset was made on a firmware that is seven years old, and older presets can be problematic to convert. Also , there is an issue with the TMA block and conversion to the III, here is a link to a possible solution, but it doesn't always work..good luck....personally I think this preset is corrupt and unusable.
https://forum.fractalaudio.com/threads/importing-effect-blocks-from-axe-fx-ii.142193/#post-1795524
 
Last edited:

xfigox

Inspired
Like what brad has said, I doubt this preset works anymore. The best you could do is to tonematch this track again with the AxeFX 3, I was using a Recto Orange Vintage model on the AxeFx 2.
 
Top Bottom