bluesk165
Inspired
It's very sorry this question repeat.
I have tried connect my AER60 amp and FX8 but it's failed with AER60s FXLoop.
Volume pedal works as following picture.
This is my pedal set up.
Volume pedal works only IN 1 and OUT 1.
IN 2/ OUT 2 are not work.
Then if I change IN 2 or OUT 2, volume pedal works to CHO/MTD/REV's MIX.
and one of my presets PRE/POST is as following,
If I change PRE/POST 4/4, 3/4, 2/4, TRM block is not work but after 3/5, it's work well.
This is my question,
1. Where is the location FX Loop in AER60?
2. When I want to use another amp such as Peveay Classc 30 and so on,
I have to change I/O CTRL at every time.
How can I set up this AER60?
Thanks.
I have tried connect my AER60 amp and FX8 but it's failed with AER60s FXLoop.
Volume pedal works as following picture.
This is my pedal set up.
Volume pedal works only IN 1 and OUT 1.
IN 2/ OUT 2 are not work.
Then if I change IN 2 or OUT 2, volume pedal works to CHO/MTD/REV's MIX.
and one of my presets PRE/POST is as following,
If I change PRE/POST 4/4, 3/4, 2/4, TRM block is not work but after 3/5, it's work well.
This is my question,
1. Where is the location FX Loop in AER60?
2. When I want to use another amp such as Peveay Classc 30 and so on,
I have to change I/O CTRL at every time.
How can I set up this AER60?
Thanks.
Last edited: