Fixed Issue in Hipower Jumped model

DLC86

Fractal Fanatic
As I've talked about here ( http://forum.fractalaudio.com/threads/hiwatt-model.120922/#post-1455635 ) I've probably found a bug in Hipower Jumped model:
Using the tonematch block as spectrum analyzer I've compared the normal channel of this model to Hipower Normal model (that should be identical) and found that in the Jumped model the normal channel has a pretty invasive high cut that I think is wrong since I've also compared it with a real vintage DR103.
As counterproof Hipower Normal model sounds almost identical to the real DR103.

In the image below you can see the comparison between the two models.

Hiwatt.JPG
 
Last edited:
It's possible to "solve" this bug with any avance parameter in AX8?
Not properly, but before the fix I used a filter block in parallel before the Hipower Normal, low cut in the filter set at 280Hz, amp's input trim at 0.500. This would give you roughly the same response of the jumped model set with both treble and normal drives at the same level.
 
Back
Top Bottom