Laszlo Varga
Member
Hi,
I'd like to connect some pedals into my axe fx III's grid and not before it.
I don't have, yet a cable which can split the pedals's signal to left and right channels and / or make one signal from the l&r channels of the output.
I think I/O 2 could be usable for sending and receiving the signal to the pedals. I found in the manual that I can configure outputs to send the same signal to both channels so I can use a single cable to come out of the axe. Can I somehow configure the input that it works properly with only one cable connected to it?
Since the signal inside the axe is stereo, I'm afraid that if I send only one of the sides (e.g. right) in than the Axe will handle it as I have sound only on one side.
Is it possible to do what I'd like to do and can you help me how can I do it?
Hope I was understandable, I'm a dummy bedroom hero.
I'd like to connect some pedals into my axe fx III's grid and not before it.
I don't have, yet a cable which can split the pedals's signal to left and right channels and / or make one signal from the l&r channels of the output.
I think I/O 2 could be usable for sending and receiving the signal to the pedals. I found in the manual that I can configure outputs to send the same signal to both channels so I can use a single cable to come out of the axe. Can I somehow configure the input that it works properly with only one cable connected to it?
Since the signal inside the axe is stereo, I'm afraid that if I send only one of the sides (e.g. right) in than the Axe will handle it as I have sound only on one side.
Is it possible to do what I'd like to do and can you help me how can I do it?
Hope I was understandable, I'm a dummy bedroom hero.