Amped
Member
I found that on power up my board didn’t go through the usual sequence of booting and timed out read on the display. I thought the board was dead as it wasn’t usable at all. The only lights that lit up were the top
Row and the display. I took the back cover off to find the 2 of the flat ribbon cables had fallen off the switch boards. I put them back on, wedged a small piece off foam that has 3m tape on one side and put them under all the flat ribbon cables so it doesn’t happen again. All is working as it should again. So if you think your board is dead, pop the cover off to make sure all the flat ribbon cables are pushed in all the way and secure. I would imagine this happened due to moving the board from gig to gig and vibration over time. Just thought I’d share this with MFC users.
Row and the display. I took the back cover off to find the 2 of the flat ribbon cables had fallen off the switch boards. I put them back on, wedged a small piece off foam that has 3m tape on one side and put them under all the flat ribbon cables so it doesn’t happen again. All is working as it should again. So if you think your board is dead, pop the cover off to make sure all the flat ribbon cables are pushed in all the way and secure. I would imagine this happened due to moving the board from gig to gig and vibration over time. Just thought I’d share this with MFC users.