I want to switch presets and scenes with one program change message.
The equipment used is FCB8N from peak.
Thank you.
What is the [Setting - MIDI/Remote - To Scene] are set for?As far as I know, that is not possible. When using a PC message, you can only change the preset, which will active the stored scene of that preset.
What is the [Setting - MIDI/Remote - To Scene] are set for?
It was possible with AX FX2.
I want to change on PC instead of CC.In Setup / Midi/Remote / Other you can set the Scene Select CC. Default is CC 34
I want to change on PC instead of CC.
I want to do what is written on page 53 of the manual.
”Another way to select Scenes via MIDI is using PC Mapping, which allows a single incoming MIDI Program
Change (PC) message to select your choice of both Preset and Scene.This is a popular option in cases where
a connected MIDI foot controller lacks the sophistication to transmit the MIDI messages required for scene
selection.”
The preset set in "To Preset" will be recalled, but "To Scene"That should work.
To do it this way:I want to change on PC instead of CC.
I want to do what is written on page 53 of the manual.
”Another way to select Scenes via MIDI is using PC Mapping, which allows a single incoming MIDI Program
Change (PC) message to select your choice of both Preset and Scene.This is a popular option in cases where
a connected MIDI foot controller lacks the sophistication to transmit the MIDI messages required for scene
selection.”
It is already on.In General Tab try setting "PC Mapping" to ON
Both are set.To do it this way:
Please note that turning on PC Mapping does effect the FC Preset functions.
- Turn ON the PC Mapping feature: (HOME->SETUP->MIDI/Remote->General page).
- Setup the Mapping to point to a preset and scene: (HOME->SETUP->MIDI/Remote->Mapping page).
Also should have Ignore Redundant PC set to ON...
Thank you. Wait for the next update.Your configuration is correct and this is a bug. I found the issue and the fix for this will appear in the next firmware release.
The scene is not recalled even if Ignore Redundant PC is turned on.Also should have Ignore Redundant PC set to ON...
To prevent the PC from being "processed" again.Why?