bluesk165
Inspired
I recently purchased an amplifier head called BluGuitar Amp1 100W.
However, a part of the its manual for setting the preset is as follows.
--------------------------------------
Every available switching possibility on AMP1™ can be recalled via MIDI programm change commands, when the corresponding command is sent from MIDI Channel 1. You can create up to 128 presets by "MIDI-Learn" assigning.
MIDI-Learn - Select the combination of Channel, Boost and Reverb you want to store.
Press the BOOST switch until the REVERB switch starts blinking. Release the Boost switch. You are now in "MIDI-Learn" mode.
Send your MIDI Program Change command to AMP1™ within 10 seconds.
Your patch is stored when the REVERB switch stops blinking.
----------------------------------
In the above manual, "Send your MIDI Program Change command to AMP1 ™ within 10 seconds."
My question here is this.
Can I “send” a command using my FX8?
If it is, How?
Thanks.
However, a part of the its manual for setting the preset is as follows.
--------------------------------------
Every available switching possibility on AMP1™ can be recalled via MIDI programm change commands, when the corresponding command is sent from MIDI Channel 1. You can create up to 128 presets by "MIDI-Learn" assigning.
MIDI-Learn - Select the combination of Channel, Boost and Reverb you want to store.
Press the BOOST switch until the REVERB switch starts blinking. Release the Boost switch. You are now in "MIDI-Learn" mode.
Send your MIDI Program Change command to AMP1™ within 10 seconds.
Your patch is stored when the REVERB switch stops blinking.
----------------------------------
In the above manual, "Send your MIDI Program Change command to AMP1 ™ within 10 seconds."
My question here is this.
Can I “send” a command using my FX8?
If it is, How?
Thanks.
