How exactly do I assign quick controlls?

blackcom

Inspired
I just wanna assign the 4 output levels on the last "output" block to quick control A, B, C and D but I cant figure out how to do it.

Anyone knows exactly how?
 
The levels are not available to any modifiers. You can put Volume/Pan blocks last in the chain, though. Then you can do it.
 
ok. Do i use the controller-page? Which tabs etc? <3

what if i add a mixer block, can i use quick controls with that one?
 
Is it possible to set the A,B,C quick controls to always be Amp Drive, Reverb Mix, Delay Mix no matter what screen I’m in or what preset. Just have them fixed at that?
 
Last edited:
Is it possible to set the A,B,C quick controls to always be Amp Drive, Reverb Mix, Delay Mix no matter what screen I’m in or what preset. Just have them fixed at that?
Yes and no. If you have the Fracpad app you can signed the knobs you want to control thta you want to use tho the quick control. But you need to press the I/O button and go to manual control when you want to change something...
 
Back
Top Bottom