bgrizzmayne
Inspired
Hey guys-
Tried gigging my axe, matrix gt1000fx and new nl212 last night at a small duo gig. It went okay, except for some reason, Icouldn't get any sound to come out of the cab in mono. My end plan is likely to run to FOH in mono and to my NL212 in stereo. Til I get that all worked out, I'm just wanting to run the NL212 in mono and I'm micing one of the speakers.
What EXACTLY do I need to have set up to run in mono? I'm using a Yek styled patch with output 1 to FOH and splitting to an FX loop to my cab.
In the I/O of my axe, I set both output 1 & 2 to Copy L -> R, even though I was only using Output 2. I'm going:
Axe left out of output 2 -> matrix in (left) ->matrix out (far left output) into the left output of my NL212. NL212 is set to mono and the NL212 is set to parallel (which is mono).
I've had problems with my axe before when if I'm not using output 1, it won't put anything out to output 2. What do I need to set up so output 2 will work without anything plugged into output 1? Also, I assume using the left output on axe, left input of matrix, left output of matrix, and left input of nl212 is cool for mono? i've always used left inputs/outputs for mono in guitar pedals etc
Tried gigging my axe, matrix gt1000fx and new nl212 last night at a small duo gig. It went okay, except for some reason, Icouldn't get any sound to come out of the cab in mono. My end plan is likely to run to FOH in mono and to my NL212 in stereo. Til I get that all worked out, I'm just wanting to run the NL212 in mono and I'm micing one of the speakers.
What EXACTLY do I need to have set up to run in mono? I'm using a Yek styled patch with output 1 to FOH and splitting to an FX loop to my cab.
In the I/O of my axe, I set both output 1 & 2 to Copy L -> R, even though I was only using Output 2. I'm going:
Axe left out of output 2 -> matrix in (left) ->matrix out (far left output) into the left output of my NL212. NL212 is set to mono and the NL212 is set to parallel (which is mono).
I've had problems with my axe before when if I'm not using output 1, it won't put anything out to output 2. What do I need to set up so output 2 will work without anything plugged into output 1? Also, I assume using the left output on axe, left input of matrix, left output of matrix, and left input of nl212 is cool for mono? i've always used left inputs/outputs for mono in guitar pedals etc