Hi all, appreciate any guidance on the below items. I have searched through the manuals, but I am not confident too say that I may have overlooked something. I am looking at doing the following:
1. I would like to have a Control Switch mapped to an FC layout that would switch between an active Wah block and an active Whammy block. My understanding from Control Switches and modifiers is that this would allow me to change which block is active across the whole preset without having to have separate scenes for each block being active. I would also like to note that I am trying to do this, as I have intentions of only having one expression pedal.
2. I would like to do something very similar with the virtual capo and have the control switch on the FC-12 cycle through the 5 tunings that i use. Once again, this would be to minimize separate presets and scenes just for changing tunings. My understanding is this is possible, and I feel like I understand the modifiers ok, but am struggling to understand how to apply the modifier to a control switch. Do I have to use the AX3 GUI or can I use Axe edit?
3. How do I export FC layouts only? Am I only allowed to export the FC layouts with System & Global Blocks? Is there a way to re-import only certain layouts?
I appreciate your comments in advance. Thanks!
1. I would like to have a Control Switch mapped to an FC layout that would switch between an active Wah block and an active Whammy block. My understanding from Control Switches and modifiers is that this would allow me to change which block is active across the whole preset without having to have separate scenes for each block being active. I would also like to note that I am trying to do this, as I have intentions of only having one expression pedal.
2. I would like to do something very similar with the virtual capo and have the control switch on the FC-12 cycle through the 5 tunings that i use. Once again, this would be to minimize separate presets and scenes just for changing tunings. My understanding is this is possible, and I feel like I understand the modifiers ok, but am struggling to understand how to apply the modifier to a control switch. Do I have to use the AX3 GUI or can I use Axe edit?
3. How do I export FC layouts only? Am I only allowed to export the FC layouts with System & Global Blocks? Is there a way to re-import only certain layouts?
I appreciate your comments in advance. Thanks!