Help out a noob

[shufflemoomin]

I'm just getting used to programming my MFC with my Ultra. I wanted to switch between the amps in a patch. I've got on IA set to Amp1 and one to Amp2, which works, but means pressing two switches. Is there a way to switch bypassing Amp1/Amp2 with just one footswitch?

 

[yek]

https://wiki.fractalaudio.com/wiki/...troller#Grouped_switches_.28switch_linking.29

 

[shufflemoomin]

Thank you kindly. Should have thought to look for a Wiki since the manual wasn't all that helpful. Thank you again.

 

[Bakerman]

You can make one switch work as an amp A/B selector if you want.

IA Axe-FX function = none
Set the IA's CC# to that of an External Control. (Refer to Axe I/O: CTRL menu)
Assign that Ext Ctrl as bypass modifier source for both amps. Swap stard/end values of one of these modifiers.

 

[Billbill]

I've noticed on some mfc tutorials folks might have a single IA with the label "Amp X/Y" always wondered how that worked. I suppose you can set any effect with this same approach

 

[unix-guy]

I've noticed on some mfc tutorials folks might have a single IA with the label "Amp X/Y" always wondered how that worked. I suppose you can set any effect with this same approach

It uses the X/Y function instead of the Bypass.

However, I think X/Y is only an Axe Fx II thing...