(implemented) Global Amp Speaker Parameters

D

Dayhawk

Member
I use a power amp and cab setup for the III and try to use Low Res parameters to help sync the amp sims better with my cab as per cliffs suggestions in the tech notes forum.

I absolutely love the Axe III but while scrolling thru presets I need to reset these parameters over and over again and I'm like... What Up With That?! :D

Is it possible to have them globally set for all presets? Or maybe a work around anyone has? Thank you for your time and consideration.
 
While researching before I wrote the thread, I found that it has been asked for before in the Axe II wishlist few times but since the last thread is about 2 years old I figure it was worth another shot.
 
You must log in or register to reply here.
Back
Top Bottom