Getting past 18 presets on FCB1010 using ripwerks

[nickxmix]

I'm running my AXE-FXII with the FCB 1010 with UNO chip and Ripwerks. How do I program the unit to change to higher banks so I can have access to more than 18 Presets using ripwerks.
Thanks in advance.

 

[paranoid]

Not sure with mods but the stock the fcb can be programed(and comes programed from the factory) to have any switch in any of the `10 banks select any preset in the first axe fx II bank. I never could figure out how to go above axe fx preset 128 when I was using the fcb with my axe fx xl.

 

[Bakerman]

Did you mean 18 presets or 128 presets?

If you don't need more than 100 (or 95 with stompbox mode) total presets accessible from the FCB, it's probably easier to store the presets you need at the lowest preset locations on the Axe-FX.

With UNO you can make an FCB preset send a bank select (CC#0) value, or set an expression pedal to a small range of CC#0 values. This allows turning certain FCB presets into bank selectors. The remaining FCB presets will recall Axe-FX presets from the bank you most recently selected.