• We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.

FX8 MKII incoming

SacredGroove

Inspired
Hello all,

I have a FX8 on the way and plan to use it in 4cm with a rack preamp. Looking at getting the Synergy Syn-2. Anyone else have this setup? How is the MIDI programming?

Thanks!
 

OrganicZed

Experienced
I'd suggest downloading the user manual to take a look at the MIDI stuff. I use scenes to send MIDI commands to either my MIDI enabled preamp or a VooDoo Lab control switcher to control the channel switching on my amp. There is also the ability to send MIDI commands by footswitch with the MIDI block, but that didn't work as smoothly for my personal use cases because I needed more than 4 different PC signals.
 

SacredGroove

Inspired
I plan on getting the manual, for sure. Sending MIDI, via scenes sounds like the way I would want to go, as well. I wasn't aware that could be done.
Thanks a lot!
 

SacredGroove

Inspired
I'd suggest downloading the user manual to take a look at the MIDI stuff. I use scenes to send MIDI commands to either my MIDI enabled preamp or a VooDoo Lab control switcher to control the channel switching on my amp. There is also the ability to send MIDI commands by footswitch with the MIDI block, but that didn't work as smoothly for my personal use cases because I needed more than 4 different PC signals.
Finally got around to programming midi. I did what you did and setup the FX8 to switch channels/functions, via scenes. I'm using it with a VHT GP3 and the manual contains all of the PC changes listed for channel and function. It's like way too simple.
 

OrganicZed

Experienced
Finally got around to programming midi. I did what you did and setup the FX8 to switch channels/functions, via scenes. I'm using it with a VHT GP3 and the manual contains all of the PC changes listed for channel and function. It's like way too simple.
Nice! I have a VHT GP3 as well (the afore alluded to MIDI preamp).
 
Top Bottom