FX LOOP

[Joero6]

Not sure why, but my fx loop is no longer working. When I turn it on, it kills the signal. Is there a setting that might have caused this? Axe fx 2 xl+ is what I have and I run a cable from output 2l to unit and back to input 2l. Have done this in the past with no issues. Joe

 

[mr_fender]

Is your front panel Out 2 knob turned up?

 

[Joero6]

Is your front panel Out 2 knob turned up?

Boom! One of the kiddos turned it off lol. Thanks Joe

 

[Billbill]

Boom! One of the kiddos turned it off lol. Thanks Joe

Ha! Rule of AxeThumb #1, never let anyone other than owner within 10ft of this machine. Even says so on rear panel!

 

[GtrGeorge]

ok...another newbie question...i have the same issue...vol2 is up...so thats good...but..no signal into the pedals input that is in the loop??? what gives?

 

[unix-guy]

ok...another newbie question...i have the same issue...vol2 is up...so thats good...but..no signal into the pedals input that is in the loop??? what gives?

You've connected Output 2 to the input of the pedal?

 

[GtrGeorge]

You've connected Output 2 to the input of the pedal?

Yes.

 

[GtrGeorge]

ok...it was me...had the cables done wrong. i was all in left (send and ret)...shouldve been both in right. Problem solved.