FX Loop silent

gdgross

Experienced
Ok, this is strangely my first time using the effects loop block. As I understand it i just insert it in chain and then can patch effects in using the out 2/in2 jacks right?

So i set up a patch that sounds fine without the block. Insert the block and run a straight cable from out 2 to in 2 and the sound disappears. Take away the FX loop block and the sound comes back.

Any ideas? gotta be something obvious i'm doing wrong I imagine...

THanks!
 
Havent used it for years but most obvious that comes to mind is volume knob ;)
Or something under "I/O" menu
or as it turns out, pluggin in the cable to the left out instead of the right, when you're only using the main L out

everyone back to your regularly scheduled forum
 
Havent used it for years but most obvious that comes to mind is volume knob ;)
Or something under "I/O" menu

I came here to say that. I just made that mistake with the fx loop volume knob only to fix it a couple days later (wondering why my effects had to be put on such a loud volume to hear only a little bit of it). Glad you fixed it @gdgross
 
Yep, I did the same thing. You can change that in the I/O settings if you want so you can use either or both. It took me hours to realize what was going on...
 
Back
Top Bottom