FW 3.0

[ATR1]

Just finished installing FW3.0. I watched video, wrote down all my setting from FW2.0. Backup 2.0. I went through and reset my settings as they were, calibrated my 2 pedals(I think). I cannot get any sound 4CM set 4pre/4post. When I move my amp placement to past block 5 I have sound or use my bypass I have sound. Anything pre appears to have very low volume. I must have 1 global setting wrong?
Thx

 

[chris]

Sounds like one of your Effects has a low volume setting.

Upload the preset and we can help

 

[ATR1]

Thanks Chris.
It was my gate in block 8 Y setting. It was muted .