Bug? Fw 16.04.1 Retrieve reverb via front panel, hold automatically on [SOLVED]

J

jeppekristoffer

Power User
When retrieving a reverb block from one preset to another then the new hold parameter almost always is on by default and the reverb time is increased as well.

These parameters do no get properly retrieved either:
Early diffusion
Early diff time
Early decay
And sometimes Type

No Axe edit or MFC connected.
No modifiers were used in non of the presets.
I've tried between many of my own presets.
And with factory presets.
Axe FX II(not XL version)

Regards Jesper
 
Last edited by a moderator:
Ok a little update.

I've tried retrieving reverb blocks from from multiple presets, both my own and factory presets.

What I've found is that, if I try to retrieve a reverb block from say preset 123 and I retrieve the block to preset 125 then the reverb parameters are not properly copied.

But if I go to preset 123 and press STORE ENTER ENTER, and then retrieve the reverb block from preset 123 to 125 then every parameter is properly retrieved.

This means that if I try to retrieve the reverb block from a preset that I've been working on and in which I've stored changes after the firmware upgrade then retrieving from that preset works as it should.
But the retrieve function does not work as intended when trying to retrieve a reverb block from a preset that has not been stored after the firmware upgrade.
 
You must log in or register to reply here.
Back
Top Bottom