Frequency of looper sysEx msg (0x23)

[bossredman]

Hi,

Once the Enable looper status messages is set - does anyone know the Looper sysex msg broadcast frequency pls?

Also is there anyway to increase/decrease the frequency?

 

[bossredman]

help anyone pls?

Need this info for help with a Looper display on my Midi Foot controller display.

 

[bobmichigan]

broadcast freq?

 

[bossredman]

From what I can see, the Looper sysex msg doesnt broadcast/update frequently enough such that I can guarentee being able to read when the Looper position byte is at either 0 & 100.
So the start of the Recorder Looper AND the end of the Played back Looper audio will not neccessarily correspond with a Looper sysEX msg being broadcast.

Wondering why that would be.

 

[bossredman]

broadcast freq?

ie How often the Looper sysex msg gets sent by the AxeFX when the Looper is activated & Looper Status Msgs is Enabled

 

[bossredman]

So with the use of a few serial.prins & te serial monitor i think the msg gets sent approx every 0.5 of a second.
It also does not neccessarily send one at 0 secs or Recorded length secs.

Any idea why this is set upthis way pls?
Any plans to change in the future?

How do I go about requesting a cgange?

 

[AlGrenadine]

I guess this message is only used to get AxEEdit display in sync, so it doesn't have to be very frequent and overload midi bus...