Software FracPad III - iOS/Android/Mac/Win Editor for the Axe-Fx II/XL/XL+, AX8/FX8, Axe-Fx III and FM3/FM9

[Dutch]

Ok it's the same situation with AxeFx III, because there are tons of new multitap types, and each parameter visibility is tied to the actual MTD type... So it will need hours to list which parameters is displayed on which type... This block is a mess...

I expected as much. The block really has a $#17load of parameters. Maybe the bare basics would be doable. Like time, feedback, pan, level... Leave the LFO, chorus, modulation, ring mods. etc., for Axe-Edit...

It's indeed a hell of a thing to just get your head around how all the params interact with eachother. F.E. (for example) the Aurora has feedback (into itself), then feedback into another delay engine (f.e. 1->2 end 2->3) for every one of 4 delays. Recipe for madness to think where the first delay repeat goes after that.
I built a "Aurora Simple" in the Delay block that gives a similar effect as the Aurora with a lot less cpu and intricacy. Just a 1/8 Dot and 1/4 Tempo. Of course it's not as gloriously lovely sounding, but who hears that in all the noise of a full band? It's a clearer and better identifiable effect when the rest of the band is playing. But not as glorious...

 

[AlGrenadine]

FracPad III 3.51 is available :
- Fixes Amp block parameters names : They're now longer and reflect more the ones used on the fasDevice/AxeEdit
- Fixes MultiDelay block parameters not shown on specific MultiDelay types. Now all parameters are always shown. Some may not act on specific MultiDelay types though
- Supports AxeFx III firmware 25.00
- Supports FM9 firmware 7.00
- Supports FM3 firmware 8.00b1

 

[Rex]

Ok it's the same situation with AxeFx III, because there are tons of new multitap types, and each parameter visibility is tied to the actual MTD type... So it will need hours to list which parameters is displayed on which type... This block is a mess...

Bring a sandwich. You’ll be at it for a while.