Below is a list of "known issues" for the FM9 version 3.00 firmware.
These are things that will be corrected or changed in a future firmware release.
Check this list for status updates and newly discovered issues as they get confirmed.
At any time this list should not be considered complete.
-Normally closed type stand-in switches do not operate properly.
-"Banner Messages" associated with foot controller actions displayed on the LCD cause the entire screen to redraw when cleared.
-Upon boot, when set to "SPDIF", the sample clock does not automatically sync if a valid SPDIF signal is present.
-The reverb effect utilizes a different wet/dry mix formula than the Axe FX III.
-The AMP effect speaker impedance graph uses a different calculation than the Axe FX III.
-The foot controller layout can inadvertently change when using a control that causes a banner message to display, ex. Tap Tempo.
-External foot controller stand-in switch assignments are not mapped correctly.
-MIDI Program Change Mapping "To Scene" setting does not have any effect.
-'Scene Revert' setting is not utilized when changing scene via MIDI CC message.
The above items all have solutions currently undergoing testing.
These are things that will be corrected or changed in a future firmware release.
Check this list for status updates and newly discovered issues as they get confirmed.
At any time this list should not be considered complete.
-Normally closed type stand-in switches do not operate properly.
-"Banner Messages" associated with foot controller actions displayed on the LCD cause the entire screen to redraw when cleared.
-Upon boot, when set to "SPDIF", the sample clock does not automatically sync if a valid SPDIF signal is present.
-The reverb effect utilizes a different wet/dry mix formula than the Axe FX III.
-The AMP effect speaker impedance graph uses a different calculation than the Axe FX III.
-The foot controller layout can inadvertently change when using a control that causes a banner message to display, ex. Tap Tempo.
-External foot controller stand-in switch assignments are not mapped correctly.
-MIDI Program Change Mapping "To Scene" setting does not have any effect.
-'Scene Revert' setting is not utilized when changing scene via MIDI CC message.
The above items all have solutions currently undergoing testing.
Last edited: