Hi, I have been using my FM3 into my FM9 via SPDIF and mainly placing anything pre-amp/cab in the FM3 and amp/cab, delays, verbs etc. in the FM9 just to balance the load....and for messing around more than thing. Note: I previous had the FM9 set to -10.0 dB on the usb/SPDIF setting so the inbound SPDIF signal wasn't;t too hot. (see https://forum.fractalaudio.com/threads/chaining-2-fm3s.183496/page-2#post-2349810)
I just updated the FM3 to Firmware Version 6.01 beta 3 and for some reason the same setup...same presets now are just a buzzy, crackly, static-filled mess? I have then reset all systems parameters etc and still no change. I also set the USB/SPDIF input all the way down to -25db+ and still the same.
Any thoughts? Any chance the new firmware could have impacted the SPDIF?
Thanks,
Derek
I just updated the FM3 to Firmware Version 6.01 beta 3 and for some reason the same setup...same presets now are just a buzzy, crackly, static-filled mess? I have then reset all systems parameters etc and still no change. I also set the USB/SPDIF input all the way down to -25db+ and still the same.
Any thoughts? Any chance the new firmware could have impacted the SPDIF?
Thanks,
Derek