FM3 Firmware Version 4.00 beta 1

[mwc2112]

Okay I notice the amp block keeps turning off and on. I had to put the Level up to 20db just to get some sound. Anyone know where I can get the down graded Firmware that works?

Haven't come across that yet. Are you connected to the old Axe Edit maybe?

 

[KwHaire]

My Input lights on the FM3 unit are hardly lighting up. Its like theirs a Gate on it. If I turn the compressor and drive on a get more sound. But still not even close to normal.

 

[Rex]

Why is everyone here named Rex?

One of us is an intruder.

 

[guitaryates]

Patiently waiting for my family to step out for a few so I can crank it.

 

[Rex]

You already fire it up Rex?

Yup. For a few days now.

 

[KwHaire]

Haven't come across that yet. Are you connected to the old Axe Edit maybe?

No, I'm on the updated version.

 

[Edrod]

Sorry if this is a stupid question, should we be resetting the amp block or doing something similar after downloading? I did a quick A and B with crap playing, but there's a huge difference in my tone.

https://www.dropbox.com/s/xcxsx2aqbwhfeok/Pre Cygnus -Cygnus.mp4?dl=0

 

[ZSauce89]

No, I'm on the updated version.

I haven’t seen the updated one yet

 

[Griff_NZ]

So is it standard practice to 'Refresh after new FW' in settings tab after any firmware upgrade?

 

[ZSauce89]

So is it standard practice to 'Refresh after new FW' in settings tab after any firmware upgrade?

Yes. See above, it’ll do it’s thing but it won’t be 100 percent until we do it with the updated FM3 edit

 

[EdgE]

Yipee no more checking forum 6. , 7 ok more times a day

 

[Aaron Queskekapow]

Was the fm3 edit updated yet?

 

[mwc2112]

No, I'm on the updated version.

I don't think it's out yet. Disconnect from your computer and see if it still happens.

 

[flashbak]

Was the fm3 edit updated yet?

Nope, still awaiting the release of it.

 

[Rublalup]

Thanks!

 

[chris]

Okay I notice the amp block keeps turning off and on. I had to put the Level up to 20db just to get some sound. Anyone know where I can get the down graded Firmware that works?

I don’t think anyone else is experiencing this or the Out 2 issue.

Out 2 copy works for me. I tested it extensively.

I’d try installing the firmware again and setting system parameters.

Anyone else have Out 2 issues?

 

[KwHaire]

OKAY! I'm so so stupid. I forgot that my Musicman Valentine has a boost pot and has a battery in the back. The battery went completely dead. Grabbed my other MusicMan Axis and everything is fine. SMH. I need a beer!

 

[chris]

OKAY! I'm so so stupid. I forgot that my Musicman Valentine has a boost pot and has a battery in the back. The battery went completely dead. Grabbed my other MusicMan Axis and everything is fine. SMH. I need a beer!

Ok good to know thanks.

 

[lauke-lux]

Wow was hoping for that. Will take care of this tomorrow morning. Thanks a lot FAS

 

[Habuman]

I don’t think anyone else is experiencing this or the Out 2 issue.

Out 2 copy works for me. I tested it extensively.

I’d try installing the firmware again and setting system parameters.

Anyone else have Out 2 issues?

Yes, Output 2 level is much lower even though Copy 1 to 2 is set.