Thanks a lot. Will check it later and report
how exactly are you setting up a Control Switch for Amp drive?I can confirm that adding CS1 to control amp drive does not work, either on my existing presets that use it, or on factory presets where I add it.
I've cycled power to the FM3 with no change in (incorrect) behavior.
I see someone else just posted controller problems also, so apparently it's not just me.
This should fix the majority and hopefully all of the USB issues. If you still have an issue, please let us know. It is always helpful if you can provide OS with version, FM3 system settings dump from Fractal-Bot, and the preset you experience the issue with (if it's a specific preset/set of presets).A question about the USB fixes. Does this address communication timeouts between the FM3 and FM3-Edit over USB? I experience occasional timeouts during an editing session of a standard preset that results in FM3 hanging, requiring a power cycle. Latest FM3 firmware, FM3 editor, FAS Windows 10 drivers.
Just downloaded and installed, and now the CS1 modifier has no affect on amp input drive. Anyone else experiencing this?
I can confirm that adding CS1 to control amp drive does not work, either on my existing presets that use it, or on factory presets where I add it.
CS1 for Input Drive is not working here either, I have it assigned to only one scene.... it does not toggle on.
Thank you for the reports! We will take a look at these and try to reproduce them tomorrow. If any of you have a chance to upload your system settings and problematic preset, that could be very helpful.I have Austin buddy pack and use CS2 on my layout to activate the boost.
the led of the switch is turning on/off and it shows Control Switch 2 on/off but has no effect on the boost
No.Is there a new FM3 Edit version required
for this Beta ?