• We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.

[fixed] New Axe-Fx III - no input level, no sound

mcmurray

Inspired
OMG - I don't have advice - but I feel your pain. Are you ok to open the top and see if that connector has popped off?

In particular - Standing at the back of the unit, with the top off - In the middle of the unit at the front there is a wide ribbon cable - To the right of that there's another ribbon cable - Also on the left hand side, there's a little input board that houses the instrument and headphone jack - There's a ribbon cable from that.. My money's on the cable that's on the front in the middle but what would I know? :)

Hope it's a simple fix
Pauly

Normally I'd take the top off and have a look, didn't want to risk voiding the warranty with how much this thing costs :)
 

mcmurray

Inspired
All fixed, apparently some connectors had worked loose during shipping. Happy with Independent Music timely communications and the quick turnaround.

If anyone else has a similar issue, before you take the cover off check the warranty conditions before doing so.
 

pauly

Fractal Fanatic
So.. what do you think? :)
HAve you got the Austin Buddy preset pack yet? I think it's a must
Thanks
Pauly
 

CobraJet390

New Member
I know this is an old thread but I ran into the same issue on my new FX III right out of the box. No input signal detected and no output. but was able to resolve it by Resetting System Parameters from the Utilities page. Maybe this will help someone else.
 

k_slim

New Member
I know this is an old thread but I ran into the same issue on my new FX III right out of the box. No input signal detected and no output. but was able to resolve it by Resetting System Parameters from the Utilities page. Maybe this will help someone else.
How exactly did you set your parameters in the utilities page? I'm having the same issue
 
Top Bottom