[fixed] Bug: Slope in Cabinet block when importing Axe-Fx III presets

yek

Contact Fractal for your Custom Title
Possible bug:

The Axe-Fx III provides separate Slope parameters for High Cut and Low Cut on the Preamp page of the Cab block.
The FM3 provides a single one.
The parameter provides 4 possible 4 dB/Oct values.

When importing an Axe-Fx III preset, the FM3 always sets the Slope to 12 dB/Oct, whatever the values are in the Axe-Fx III preset.

This may or may not be a factor in audible differences between otherwise similar presets on both devices.
 
I think that this has already been addressed in what will be the next beta.
If I understand correctly, the cab block filters section will now be in sync with Axe-Fx III.
Note the potential that filters with increased slope will use a bit more CPU.
 
I think that this has already been addressed in what will be the next beta.
If I understand correctly, the cab block filters section will now be in sync with Axe-Fx III.
Note the potential that filters with increased slope will use a bit more CPU.
This.
 
I think that this has already been addressed in what will be the next beta.
If I understand correctly, the cab block filters section will now be in sync with Axe-Fx III.
Note the potential that filters with increased slope will use a bit more CPU.

Well, that's a coincidence. :)
 
Back
Top Bottom