Mediocrity
Member
I got a new FCB1010 a couple of weeks ago and immediately calibrated the expression pedals. While doing so I noticed that they don't really start to send values until the pedals are 50% down - ie the heel value starts at 07, then with the pedal 50% down the value is 09 and then there is a flurry of values until at 100% down the value reads E7.
I assumed the board was faulty and returned it for a replacement. The new one arrived today and it's exactly the same. Is this normal on these controllers and if so, how do you set a proper taper if the pedal isn't even sending values until the pedal is halfway down? :?
I assumed the board was faulty and returned it for a replacement. The new one arrived today and it's exactly the same. Is this normal on these controllers and if so, how do you set a proper taper if the pedal isn't even sending values until the pedal is halfway down? :?