FCB1010 and Wah

gigawatt

gigawatt

Experienced
I was going through the manual and what I found were only instructions for an external expression pedal. As most of you know the 1010 has two built in exp. pedals. There must be a way to use them for wah. volume, wammy, CC, etc., but I haven't been able to figure it out as of yet. Any help would be greatly appreciated. :)

Sorry if this has been explained b4, if it has please direct me to the thread.

Thanks
 
On the Axe-FX, go to 'Setup' -> 'MIDI/Remote' and page over to the 'External' tab. Choose 'External Control 1', hit Enter so the Axe-FX will try and learn the MIDI CC that the 1010 is sending. Move the one of the pedals around, it should learn the MIDI # for it. Then do the same for 'External Control 2'. Now in your Volume/WAH block, you can set a modifier to use 'External' 1 or 'External 2'. If you need more help, let me know.

Edit: Here is a video for how to do this the II, the same process applies to the III

 
Last edited:
Hey thanks much Chad! Is this in the III's manual anywhere? If it is I haven't been able to find it. I remember it in the Ultra's though...
 
You must log in or register to reply here.
Back
Top Bottom