FC layout selection in Axe-Edit and on the FC-12 not in sync?

should FC layout changes using FC-12 change the FC layout selection and display in AXE EDIT and vice versa? This is not working on my units. Regards Urs :)
 
should FC layout changes using FC-12 change the FC layout selection and display in AXE EDIT and vice versa? This is not working on my units. Regards Urs :)
I have not seen this happen to date.

Methinks it is normal operation for the layout in AxeEdit to not be synchronized with the FC-12's current layout.

This makes it possible to edit a layout which you are not currently using.
 
Intended behavior.

I like to learn more:
For myself i miss that this is not possible and that this feature behaves differently than most others that can be operated via AXE EDIT.

What is the background or the requirement for this?
How should the workflow be?
Would "synchronous" behavior conflict with other requirements or Workflows?
 
Axe-Edit is an editor. You edit the Layouts as needed, then use the FC to perform calling up the Layout as needed.

When you click blocks or other things in edit, nothing changes on the Axe, so I don’t see how this is different.
 
Would "synchronous" behavior conflict with other requirements or Workflows?

Sounds like a good idea until you have more than 1 FC connected. Which FC would be changed, all of the connected ones change to the selected layout, just FC1 or FC2, etc. I think this would be problematic.
 
Back
Top Bottom