trancegodz
Fractal Fanatic
I wish that the LED was dimmed when a channel was off and bright when it was on.
Right now if you have a channel (of say a drive block) assigned to a foot switch on the FC-12 the LED around the footswitch is not lit at all until you step on the footswitch. It’s hard to see where the foot switch is in the dark.
The way it works now is that if you have the FC-12 set up as follows :
Footswitch #1 = Drive 1 channel A = Octavia
Footswitch #2 = Drive 1 channel B = Fuzz Face
Footswitch #3 = Drive 2 channel A = Micro Boost
Footswitch #4 = Drive 2 channel B = TS808 Tube Screamer
None of the first four LEDs are lit at all in the above example. If you step on foot switch #1 it then lights up bright, and at the same time footswitch #2 will come on lit up dimmed. Footswitch #3 & #4 LEDs are off completely.
If you then step on say foot switch #4 (so you have the Octavia and TS808 on together), now footswitch #1 and #4 are lit up brightly, and #2 and #3 are lit up but dimmed.
Right now if you have a channel (of say a drive block) assigned to a foot switch on the FC-12 the LED around the footswitch is not lit at all until you step on the footswitch. It’s hard to see where the foot switch is in the dark.
The way it works now is that if you have the FC-12 set up as follows :
Footswitch #1 = Drive 1 channel A = Octavia
Footswitch #2 = Drive 1 channel B = Fuzz Face
Footswitch #3 = Drive 2 channel A = Micro Boost
Footswitch #4 = Drive 2 channel B = TS808 Tube Screamer
None of the first four LEDs are lit at all in the above example. If you step on foot switch #1 it then lights up bright, and at the same time footswitch #2 will come on lit up dimmed. Footswitch #3 & #4 LEDs are off completely.
If you then step on say foot switch #4 (so you have the Octavia and TS808 on together), now footswitch #1 and #4 are lit up brightly, and #2 and #3 are lit up but dimmed.