External fx processor and fx loop

Souq47

Member
Hi, everyone!

Sorry if there's already a thread about this but here it goes:

I'm trying to have a dual amp setup using the AX8 in combination with the Line 6 HX Stomp, the AX8 doing the guitar amp and effects, and the Line 6 with a bass amp sim and octave effect. I've done this before with a splitter dividing the signal, one into the AX8 and the other into the L6, but that caused some phasing problems and also I want to have the mix under my control and not leave it to the sound guy. I want to send the whole package ready to go.

The thing is I don't know if I'm able to achieve this, and if so how I can do it. I'd like to have for example the guitar signal on channel 2 and the L6 signal (in fx loop) in channel 3 completely independent, and then mix them in the output mixer of the AX8 and turn the fx loop off whenever I don't want the "bass" signal. Even better, is it possible to have the AX8 signal going through the stereo XLR outs and the L6 signal going through the L (mono) jack out?

If all this is possible, how should I setup the fx loop?

Thanks in advance!

Jorge
 
Last edited:
Back
Top Bottom