Peromustejn
Member
I have a Behringer FC600 pedal. The pedal is connected to the FC6 with a TRS cable.
The issue I am having is when I do the calibration, the slider registers the whole throw of the pedal, but when creating a modifier I have a big dead spot at the toe-position. Nearly half of the total throw.
I measured the resistance and in toe-down is 0 ohm, hell-down is 50k.
The modifier moves (yellow dot) only in the range from 24k to 50k on the pedal. Hope that make sense.
Both the axe and fc6 are on the latest versions.
The issue I am having is when I do the calibration, the slider registers the whole throw of the pedal, but when creating a modifier I have a big dead spot at the toe-position. Nearly half of the total throw.
I measured the resistance and in toe-down is 0 ohm, hell-down is 50k.
The modifier moves (yellow dot) only in the range from 24k to 50k on the pedal. Hope that make sense.
Both the axe and fc6 are on the latest versions.
