Fro
Experienced
When I attach my expression pedals to a block like Wah or Volume, I always set my Auto-Engage to Medium Position and my Off Value to 95%. I leave all of my expression pedals in toe position when not in use. With the Axe Fx II, there was always this thing I would have to do when I first turned the unit on for the unit to recognize the pedal position, and that was just to move each pedal down to heal position and back up to toe position. Then I would be fine for the rest of the night. Oddly enough, I never had to do that with the Axe Fx Standard, but it was something I quickly got used to with the Axe Fx II. Power up, move pedals, good to go.
Well, the Axe Fx III is forgetting what the pedal position is every time I use the tuner. It's like I'm turning the unit on for the first time. So now it's power up, move pedal, good to go. Use tuner, move pedals, good to go. I'm not sure if this has to do with the fact that I'm now using the MFC-101 as a straight midi controller without 2-way communication, or if expression pedal states get reset when the tuner is used, much like powering on for the first time. Anyone else set their pedals in a similar way and run into this?
Well, the Axe Fx III is forgetting what the pedal position is every time I use the tuner. It's like I'm turning the unit on for the first time. So now it's power up, move pedal, good to go. Use tuner, move pedals, good to go. I'm not sure if this has to do with the fact that I'm now using the MFC-101 as a straight midi controller without 2-way communication, or if expression pedal states get reset when the tuner is used, much like powering on for the first time. Anyone else set their pedals in a similar way and run into this?