How about correct biasing for 90V?Set the Variac parameter in the Amp block at 75% to simulate 90VAC to the amp.
6CA7's are in the power tube options.
I believe pulling the negative feedback from the 4 ohm tap instead of the 8 ohm tap would give half the voltage, so I would guess reduce the default negative feedback setting by half.
Should be 70.71%. To end up at half, it would need to be 1/4 the impedance.I believe pulling the negative feedback from the 4 ohm tap instead of the 8 ohm tap would give half the voltage, so I would guess reduce the default negative feedback setting by half.
This sounds damn close
Hehe didn't start slaving until the 1984 tour, and he didn't use to slave when recording.Did I miss something? There was no mention of the dummy load into the SS H&H power amp. Maybe that was just for live stuff?