Hi Guys.
Okay. My delay, Verb, chorus] are in parallel bad on confusing you. I set up two paths 1- Wah/ filter block (but it could be anything with its bypass parameter set to off the other 2- Comp / GEQ again with its bypass paranetervset to off. They both can’t be on at the same time. The volume pedal is later in the chain after drives and amp before delays and verbs. . It’s bypass paraneter is set to Thru.
Sone scenes. The filter is unbypassed (doing nothing but passing signal) when this is on the volume block is bypassed (no volume) and als the GEQ block is bypassed (no Compressor)
Other scenes the Filter block is bypassed (no Wah) the GEQ block is unbypassed allowing the signal from the compressor through. When thus happens I can leave the volume block bypassed or if I unbypassed it the volume is controlled by the ev2 before the delay./verb
The Ev-2 is always controlling the WAH and Volume pedal they just can’t be on at the same time. That’s why two paths. One path is strictly to take the Wah out of the signal chain. I don’t normally use the compressor block with distortion or overdrive. So that’s in path two.
Ignore the first delay block that set up for reverse delay. The volumepedal is before the main delay block, reverb and chorus.
This preset for me is set up.
Scene 1 Wah, filter amp x, cab, [verb in parallel ]
Scene 2 comp, GEQ Trem, amp x, cab, volume [delay x, Verb, chorus] are in parallel
Scene 3 Wah, filter, pitch, drive, amp y, cab, [delay x, Verb] are in parallel
Scene 4 Wah, filter, drive, amp y, cab, [delay x, Verb,] are in parallel
Scene 5 Wah, filter, amp y, cab, [verb in parallel]
Scene 6 comp, GEQ, pitch, reverse delay, amp x, cab, volume pedal, delay x, Verb, chorus] are in parallel
Scene 7 comp, GEQ , drive, amp y, cab, volume pedal, [delay x and verb in parallel]
Scene 8 comp, geq, amp x, cab, [delay y, verb, chorus in parallel]
Amp X clean super verb
Amp Y dirt plexi1987
Delay 1 in parallel mix level 100%near end of chain
Main delay X is setup for dual deal (either amp tempo of timed for songs) input level 29%
Main delay Y us set up for dotted eighth notes input level 100%
Delay 2 in series right before drive block input level 50%
Delay 2 x reverse delay mix level 100%
Delay 2 y dotted eighth. Mix level 45%
Filter block not usually set to do any thing but pass signal or mute signal. (Could be used to boost gain into amp)
Geq block (used to pass signal or mute signal. (Can be used to enhance certain frequinces fir ckean sounds)
Wah is set to auto engage. Controlled by EV 2
Volumpedal is controlled by EV 2
This is for the AX8. The Axe fx II and III can be done differently and easier but the AX 8 fits nicely in a lop briefcase on planes. :0).
Hope that helps. I did a Facebook live on this but I think the signal dropped in and out. I’m back in the USA now I’ll do one from my studio with good WiFi
It’s the same concept with Wah, Volume and Whammy. Just replace the compressor with a pitch block