Bought a used MFC off the forum, the firmware was older than 1.0 ...
Read Yeks Wiki on how to update, using Midiox through the AxeII to the MFC.
File starts to go, MFC gets up to some number - and Error 14 pops up.
Tried the buffer settings like Yek suggested ... 7 attempts have failed. Now all I get is Error 14, even when I try to hold #11 and power up for a reset. The only time the Error does not show is when I go to the firmware update mode.
Any help out there???
Thanks
Read Yeks Wiki on how to update, using Midiox through the AxeII to the MFC.
File starts to go, MFC gets up to some number - and Error 14 pops up.
Tried the buffer settings like Yek suggested ... 7 attempts have failed. Now all I get is Error 14, even when I try to hold #11 and power up for a reset. The only time the Error does not show is when I go to the firmware update mode.
Any help out there???
Thanks