Dual Delay in mono

adew

adew

Inspired
It's been a long time since I ran my AxeFX in mono (Output 1 Copy L>R), and seem to have forgotten some basics. So, a question about Dual Delay pan parameters. When outputting in mono, should I be setting L and R Pan parameters in the DLY block to 0% (they default to -100% and 100% respectively)?
Thanks!
 
copy left to right just means you won't hear anything that is being only sent to the Right channel. so anything set to 100 for the pan just won't be heard at all.

FYI if you leave the output mode set to Stereo and just use a cable out of the Left output, it's the exact same as Copy L>R.
 
If you use the copy L->R functionality and you *don't* pan your delays dead center, but leave them hard panned like that, you won't hear your right-panned delay at all. If you use anything other than center panning, the right panned delay will sound quieter than the left panned delay.
 
You must log in or register to reply here.
Back
Top Bottom