HarryTheAxe
New Member
Hi guys,
I'm trying to figure out the best way to setup a preset with two amps at once. I'm the only guitar player in my band and I always used two amps before I started using AxeFx. And I feel like it's very essential part of my sound.
So what I came up with so far:
1. Two amp blocks. X/Y switching on both to switch between clean and dirty amps. This doesn't work for me because the lag is too big.
2. Two clean amp blocks w/ drive before them. In this situation cleans are fine, but I never managed to get the drive sound as good as dirty amp.
3. Two dirty amp blocks. In this scenario distortion sounds are amazing. But need to find a way to clean up them. Assign some knobs to scene controllers or something...
What do you think of these options? What do you use? Any advice much appreciated.
I'm trying to figure out the best way to setup a preset with two amps at once. I'm the only guitar player in my band and I always used two amps before I started using AxeFx. And I feel like it's very essential part of my sound.
So what I came up with so far:
1. Two amp blocks. X/Y switching on both to switch between clean and dirty amps. This doesn't work for me because the lag is too big.
2. Two clean amp blocks w/ drive before them. In this situation cleans are fine, but I never managed to get the drive sound as good as dirty amp.
3. Two dirty amp blocks. In this scenario distortion sounds are amazing. But need to find a way to clean up them. Assign some knobs to scene controllers or something...
What do you think of these options? What do you use? Any advice much appreciated.