Does pasting a channel to a new amp block require resetting with new firmware?

MisterE

MisterE

Fractal Fanatic
With the new Cygnus FW, it's best to reset the amp blocks.
In order to avoid going over all the parameters, I was thinking of the following:
  • Save the amp block to the library.
  • Soft reset each channel - or do I need to do a hard reset?
  • Insert the amp block from the library (as AMP2)
  • Copy each channel from AMP2 to AMP1

Would this work or do I have to change each parameter manually on AMP1?
 
Good question... I know there are some "unexposed" settings in the Amp block that a reset would adjust. I suspect that there may be other user accessible settings that you may not have changed but that a reset may change to a new default. In that case, pasting settings would revert those back to pre-order updated defaults (instead of the new defaults).

I think if there was an "easy" solution to this (Fractal) age old "problem" it would be documented.

It would definitely be appreciated!
 
You must log in or register to reply here.
Back
Top Bottom