Hello everyone
So I finally done soldering and connecting everything,
I attached a piece of wood at the edge with screws to add some stability, i also gonna glue some spray paint caps in the middle to make it even more stable.
But before uploading the code and try it, I wanted to share with you how I connect the LCD and the Midi Plug to confirm if everything is done right.
For the 16x2 LCD (couldn't find any larger LCDs), I connected as shown in here
For the Midi-out I connected it as follows :
Midi Pin 2 to ground pin (below pin 53)
Midi pin 4-220 ohm resistor to +5V (above pin 22)
Midi pin 5-220 ohm resistor to Tx3
* I Left the other Midi-in plug unconnected because I don’t think I need a Midi-in for now.
Now before I learn how to code the Arduino board properly to match what I exactly need to do with the FC which going to take some time, I need to play around with the FC and try some of the already built codes in this thread. and as I’m going to try it with my Axe fx II XL+, I think the most suitable code is ver 6.9 in post #21 by
@Piing ? or is there’s another recommended version ? since most of the other versions are made for the AXE FX III
I belive.
Also is there any settings you advice to change in the AXE unit before I connect the FC ?
Thanks