DATS to Speaker Impedance Tab Parameters

A while back when I measured my cab and tried to get it into the axe FX (as I prefer SS power amp and real cab). I took a screen shot of the axe edit speaker page, then overlayed my plot and shrunk and stretched it in photoshop until the frequencies lined up. Luckily in axe-edit we can see where 200hz and 2khz is so I could align those. No vertical scale though so I had to do ‘best guess’.

The ‘slope’ parameter especially was quite a bit higher for my cab, it has a very profound effect on the mids and treble. Overall a great improvement, I saved the settings so I can adjust them whenever I want to select a new model.

Kind of a rough approximation only but better than nothing.
 
Back
Top Bottom