• We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.

Bug? Custom Switch naming on unit can produce out of bounds error

moerker

Inspired
The problem happens if the custom name uses all of its 10 characters, and advancing one additional place (to an 11th character) by using the Cursor (control B). Pressing „Store“ results in the garbeled name as seen below. This persists until you are deleting the character explicit.
Firmware is 4.01.

I attached an image showing the result.
 

Attachments

  • 822FD335-37D7-455C-8A09-6AF9AB22ECE7.jpeg
    822FD335-37D7-455C-8A09-6AF9AB22ECE7.jpeg
    1.7 MB · Views: 8
Top Bottom