RShakelford
Member
I'd like to set up my AXFX2 MKI to run two physical amps and an AXFX2 modeled rig. After searching the manual, you tube, and the forums, I'm at a loss. Any help would be appreciated.
Here's are the specifics of what I'm trying to do
1) 1 guitar input (I do also have an AB/Y splitter if this would help)
2) I'd like to run a few stomp boxes in front of the axefx (mostly OD/dirt)
3) Real amp #1 = axefx2 effects to be used in amps fx loop....no amp simulation (4CM type of control would be ideal)
4) Real amp #2 = same as one BUT amp #2 doesn't have an effects loop. (obviously don't expect 4CM control)
5) Amp #3 = Axefx 2 amp/cab and hopefully effects thru my studio monitors
If I still had my hair, I'd of torn it out
. Anyone know if this is possible? If so how in the hell do I wire this up and configure the blocks & I/O settings for the correct routing. If you have read this far: Thanks!
Here's are the specifics of what I'm trying to do
1) 1 guitar input (I do also have an AB/Y splitter if this would help)
2) I'd like to run a few stomp boxes in front of the axefx (mostly OD/dirt)
3) Real amp #1 = axefx2 effects to be used in amps fx loop....no amp simulation (4CM type of control would be ideal)
4) Real amp #2 = same as one BUT amp #2 doesn't have an effects loop. (obviously don't expect 4CM control)
5) Amp #3 = Axefx 2 amp/cab and hopefully effects thru my studio monitors
If I still had my hair, I'd of torn it out
. Anyone know if this is possible? If so how in the hell do I wire this up and configure the blocks & I/O settings for the correct routing. If you have read this far: Thanks!
Last edited: