Changing input levels in patches

[nscali]

Hi
I am sure this has been asked numerous times but....
I generally use humbuckers so my master input level is set accordingly - around 50-55% - guitar depending.
From time to time I use a strat, which has a much lower output and I therefore need to increase the input level.
I would like to be able to set up specific patches for my strat with an increased input level, without needing to change the master level. Is this possible?
Thanks for your help.

 

[deftim13]

Not possible but def. has been requested before.

 

[yek]

I/O > Input Level does not control input level, but signal-to-noise ratio.
No need to change this when switching to your strat.

Check this for a solution for your wish :
Connecting a guitar - Axe-Fx II Wiki

 

[Jleavitt]

I turn the AMP block input trim down from 1.0 to 0.5 when changing to humbuckers from single coil pickups, read that here I believe. Turns out you can use scene controllers to change AMP block input trim per scene, scenes 1-4 single coil (input trim = 1.0) scenes 5-8 humbuckers (input trim= 0.5) for example.