Change Reverb Level with an IA

[Tonemaster]

Don't know if this can be done, but I'd like to be able to set an IA such that the verb in on with an initial value when the patch loads. Then, by pressing the IA again, the level goes up by some CC controlled value. Basically, want to adjust reverb level up/down a fixed amount with an IA and not a pedal. I want to do this with Delay in the same patches and don't want multiple pedals.

Like I said, don't know if this is possible, but any insight is greatly appreciated!

 

[Bakerman]

It's similar to setting a pedal up to control a wah, whammy, etc. Set the switch up as a general use IA, using the CC# of an external in the I/O menu. Assign that external to reverb input gain and/or other things in the preset, adjusting modifier start/end values to get the desired result.

 

[dirtypurple]

You could also do that using an internal cc to set the initial value when the preset loads then have an IA setup with a min value greater than the internal cc
If that makes sense

Or set up the IA with a min value other than zero ?